Dual occupancy detector LB101. The LB101 contains two independent occupancy detectors, each of which can be used to detect that a train or piece of rolling stock occupies a section of track. It operates on the “current sensing principle”. The LB100 only detect occupancy when there is a "current consumer" within the monitored track section (detection...
The SILVER direkt + was designed especially for locomotives equipped with an 8 pin NEM652 interface. The decoder pins are located directly on the circuit board so that the decoder can be simply plugged onto the interface. It doesn’t get any
Auto reverse loop module LK200 for DCC systems. With short circuit detection, enables the change of polarity automatically in reverse loops, turntables, etc. Easy-wiring installation, with only 4 wires to connect, and no additional control
The Silver+ mini decoder is a less expensive variant of Gold decoders. More upmarket features (e.g. USP) have been omitted to facilitate the design of a low-cost, easy-to-install decoder. Except for USP, the Silver+ decoder has all other Gold decoder
The SILVER 21 is like the Silver +, but equipped with a 21 pin interface plug located on the circuit board and even more space saving due to its 2.5 mm shorter design.
Switch decoder LS150. Up to six points, signals etc. can be connected to the switch decoder LS150. The switch decoder requires a separate power supply, preferably a transformer TR100. This means that AC is applied to the outputs. The maximum load is
Locomotive decoder STANDARD+, equipped with all features considered standard for a DCC locomotive decoder, and also supports the RailCom function.
Silver Mini + Decoder, without wires and with NEM 651 plug.