Auto reverse loop module LK200 for DCC systems. With short circuit detection, enables the change of polarity automatically in reverse loops, turntables, etc. Easy-wiring installation, with only 4 wires to connect, and no additional control
The Silver+ mini decoder is a less expensive variant of Gold decoders. More upmarket features (e.g. USP) have been omitted to facilitate the design of a low-cost, easy-to-install decoder. Except for USP, the Silver+ decoder has all other Gold decoder
Digital decoder with sound for RENFE 440R units, manufactured by ESU. It is 21-pin decoder with independent speaker.
Digital decoder with sound for RENFE 7200 locomotives, manufactured by ESU. It is 21-pin decoder with independent speaker.
Digital decoder with sound for RENFE 251 locomotive. Made by ESU.
Digital decoder with sound for RENFE TRD units, manufactured by ESU. It is 21-pin decoder with independent speaker.
The new Z21 Digital Unit for smartphones (Iphone o Android) and tablets (Ipad o Android). This unit open a new time in the digital era, providing a quick and intuitive operation, both of the layout and trains. Multi-protocol central module for DCC
Digital decoder with sound for RENFE 321 locomotive.
Digital decoder with sound for RENFE UT300 units, manufactured by IBERTREN. Suitable for references 46040-1-2-3-4. It is 21-pin decoder with independent 23 mm speaker.
21 pins decoder especially configured for the RENFE 7200/7500 locomotive from ELECTROTREN (ref. 3016).
Cable harness with 6-pin plug, according to NEM 651, DCC colour. Wires length 300 mm.
Loksound decoder for 030 RENFE locomotive. Suitable for references MABAR 82200 and 82201.
Decoder con sonido para los automotores eléctricos 432 de RENFE. Muy fácil de instalar gracias al conector NEM que tienen estas unidades. El sonido es el real del automotor, ya que el decoder ha sido fabricado en especial para este
Doehler Hass decoder with the iconic sounds of this train.
The SILVER 21 is like the Silver +, but equipped with a 21 pin interface plug located on the circuit board and even more space saving due to its 2.5 mm shorter design.
Switch decoder LS150. Up to six points, signals etc. can be connected to the switch decoder LS150. The switch decoder requires a separate power supply, preferably a transformer TR100. This means that AC is applied to the outputs. The maximum load is
Locomotive decoder STANDARD+, equipped with all features considered standard for a DCC locomotive decoder, and also supports the RailCom function.
Silver Mini + Decoder, without wires and with NEM 651 plug.